 |
 |
 |
|
 |
|
|
|
#1
|
|||
|
|||
quick raid buttons in raid
okay, my main box crashed so I had to run on a back up box. I thought my ui was just a copy and past of my main but something is different...
On my main box, the QR buttons work as expected in both group mode and raid mode. However, on my backup box (both of which use auto updater) only group QR buttons work. The in raid all it says is parent.target.swashbuckler.button1.... etc etc. Its like the buttons are not programmed. Its early now (when I did this it was late last night) so I am sure I did something stoopid. Anyone care to enlighten me on what I did wrong? /start flame mode now Thanx! 
|
|
#2
12-09-2007, 03:01 PM
|
|||
|
|||
|
It would be easiest to try a clean install - remove at least all .xml files from the ProfitUI folder and have the updater pull them down again.
__________________
P R O F I T U I ∙ R E B O R N [Auto-Updater] | [Portal] | [F.A.Q.] | [Support Forums] ~ Retired ~ If it does not work, you likely installed it incorrectly. Always try a clean install before reporting bugs.
|
Hybrid Mode
 |
© MMOUI
vBulletin® - Copyright ©2000 - 2026, Jelsoft Enterprises Ltd. |
 |
